Re: trailing characters in olcserverids after conversion

[Oliver Liebel <oliver@itc.li>]

thanks for your response.
i have tested it several times under different conditions,
the result was always the same.
i will file it as an its.

greetings
oliver

Pierangelo Masarati schrieb:
> Oliver Liebel wrote:
> > using openldap 2.4.13 (compiled from openldap.org source-package)
> > i have noticed the following, reproducable behaviour when converting
> > a slapd.conf to slapd.d:
> >
> > if slapd.conf contains serverids with ldap-urls, e.g. in this format:
> >
> > ServerID        1       "ldap://ldapmaster.local.site:9000";
> > ServerID        2       "ldap://ldapslave.local.site:9000";
> >
> > the olcserverids always contains some trailing (garbage) characters 
> > after the
> > conversion, and are base64 encoded.  when i set them manually in 
> > cn=config with
> > ldapmodify, they are displayed "clean".
> >
> > the serverid-lines in  slapd.conf are "clean" (they contain no 
> > whsp/tabs at the end
> > of the line or similar, invisible chars).
> > i have tested it without \"\ and without portnumber,
> > tested conversion with slaptest and slapd,
> > in virtual and real machines,
> > result is always the same.
> >
> > any ideas?
>
> If this behavior is consistently reproducible, I suggest you file an 
> ITS <http://www.openldap.org/its>.
>
> p.
>
>
> Ing. Pierangelo Masarati
> OpenLDAP Core Team
>
> SysNet s.r.l.
> via Dossi, 8 - 27100 Pavia - ITALIA
> http://www.sys-net.it
> -----------------------------------
> Office:  +39 02 23998309
> Mobile:  +39 333 4963172
> Fax:     +39 0382 476497
> Email:   ando@sys-net.it
> -----------------------------------