Re: syncrepl refreshing data from new master

["Gabriel Stein" <gabrielstein@gmail.com>]

Hi,

Do you tried setup the retries directive at consumer(slave?)

From OpenLDAP Admin Guide:

If an error occurs during replication, the consumer will attempt to
reconnect according to the retry parameter which is a list of the
<retry interval> and <# of retries> pairs. For example,
retry="60 10 300 3" lets the consumer retry every 60 seconds for the
first 10 times and then retry every 300 seconds for the next three
times before stop retrying. + in <# of retries> means indefinite
number of retries until success.

Cheers.

On 9/26/07, Arunachalam Parthasarathy <arunachalamp@huawei.com > wrote:

Hello all,

I am using openldap 2.3.36 In normal refresh and persist mode of sync replication, when I dynamically change the uri of the master server in slave, how to instruct the slave server to refresh the whole data from the new master server

Thanks in advance,

Arunachalam.

 

********************************************************************************************************
 This e-mail and attachments contain confidential information from HUAWEI, which is intended only for the person or entity whose address is listed above. Any use of the information contained herein in any way (including, but not limited to, total or partial disclosure, reproduction, or dissemination) by persons other than the intended recipient's) is prohibited. If you receive this e-mail in error, please notify the sender by phone or email immediately and delete it!

 

-- 
/\
Gabriel Stein
gabrielstein@gmail.com
MSN: gabrielstein@hotmail.com
Administrador de Redes - 
Network Administrador
Linux User #223750
51-92796310
Porto Alegre - RS - Brasil