RE: Slapd config for heavy and medium load

["Rajarshi Chaudhuri" <rajarshi@genesyslab.com>]

In both cases [a & b] - mostly writing than reading.

There are multiple faq entries for bdb tuning. The thing I'm asking for is a consolidated block in which if you can mention the parameters (I know most of them) and their recommended values (the values or their range is important).

Rajarshi Chaudhuri
Genesys Telecommunications Lab, Inc
rajarshi@genesyslab.com


-----Original Message-----
From: Quanah Gibson-Mount [mailto:quanah@stanford.edu] 
Sent: Thursday, February 08, 2007 3:06 PM
To: Rajarshi Chaudhuri; openldap-software@openldap.org
Subject: Re: Slapd config for heavy and medium load



--On Thursday, February 08, 2007 11:43 AM -0800 Rajarshi Chaudhuri 
<rajarshi@genesyslab.com> wrote:

>
>
> Hi,
>
>
>
> I would highly appreciate if someone can provide the following â
>
>
>
> a.       A sample bdb section for slapd.conf that shows what parameters
> need to be configured and to what values [may be a range] for
> withstanding a relatively heavy load [about 50 â 150 concurrent users
> each pumping a lot of data]. Also if some parameters should be configured
> in a DB_CONFIG file. Also â the thread pool size is important.


Writing or reading?


> b.       A sample bdb section for slapd.conf that shows what parameters
> need to be configured and to what values [may be a range] for
> withstanding a medium load [about 10 â 15 concurrent users each pumping
> some data]. Also if some parameters should be configured in a DB_CONFIG
> file. Also â the thread pool size is important.

Writing or reading?

> There are lots of material in the archive regarding this â but not with
> much specificity. So if someone summarizes this in one place that would
> be of great help.

Did you read the FAQ entries about tuning BDB?

--Quanah



--
Quanah Gibson-Mount
Principal Software Developer
ITS/Shared Application Services
Stanford University
GnuPG Public Key: http://www.stanford.edu/~quanah/pgp.html