[Date Prev][Date Next]
[Chronological]
[Thread]
[Top]
RE: installation problems
It shouldn't matter about that. The point is all the required software has
been installed for OpenLDAP without problems. Its just OpenLDAP that hangs.
Dave
_____
From: Tay, Gary [mailto:Gary_Tay@platts.com]
Sent: Tue 10/18/2005 10:22 AM
To: Henderson, David
Cc: openldap-software@OpenLDAP.org
Subject: RE: installation problems
I don't use Debian and have no comment.
Gary
-----Original Message-----
From: Henderson.David@mail.dc.state.fl.us
[mailto:Henderson.David@mail.dc.state.fl.us
<mailto:Henderson.David@mail.dc.state.fl.us> ]
Sent: Tue 10/18/2005 9:50 PM
To: Tay, Gary
Cc: openldap-software@OpenLDAP.org
Subject: RE: installation problems
Gary,
I am compiling the software on Debian 3.1 (Sarge). This is the
latest release of the distro's GNU/Linux. Is there anything that I can look
into to see what the problem is?
Thanks,
Dave Henderson
_____
From: Tay, Gary [mailto:Gary_Tay@platts.com
<mailto:Gary_Tay@platts.com> ]
Sent: Tue 10/18/2005 12:09 AM
To: Henderson, David
Cc: openldap-software@OpenLDAP.org
Subject: RE: installation problems
What OS are you using? are you using a very old version of OS? Eg:
RH9
or Solaris2.6? Please upgrade the OS to RHFC3 or Solaris8 or later.
Gary
-----Original Message-----
From: owner-openldap-software@OpenLDAP.org
[mailto:owner-openldap-software@OpenLDAP.org
<mailto:owner-openldap-software@OpenLDAP.org> ] On Behalf Of
Henderson.David@mail.dc.state.fl.us
Sent: Monday, October 17, 2005 9:04 PM
To: Tay, Gary
Cc: openldap-software@OpenLDAP.org
Subject: RE: installation problems
Gary,
Just to double check... the ssl package installs to
/usr/local/ssl (using default paths for installation)? I moved the
previously compiled openSSL package to a .org directory (mv
/usr/local/ssl /usr/local/ssl.org), then ran the following:
Make clean
./config shared
make
make test
make install
Everything appeared to go fine. I then tried to recompile OpenLDAP,
but
still got the same problem during compile. Are there any issues
with
conflicts between certain versions of the software? Here are the
following versions I am trying to use:
openSSL 0.9.8
bdb 5.2.52
cyrus sasl 2.2.21
openLDAP 2.2.26
Thanks,
Dave Henderson
MCP, MCSA, MCSE, A+
Distributed Computer Systems Analyst
Florida Department of Corrections
Phone: 407.207.7391 Suncom: 343.7391
-----Original Message-----
From: Tay, Gary [mailto:Gary_Tay@platts.com
<mailto:Gary_Tay@platts.com> ]
Sent: Friday, October 14, 2005 1:30 PM
To: Henderson, David
Cc: openldap-software@OpenLDAP.org
Subject: RE: installation problems
This FAQ entry would be informative to you.
http://www.openldap.org/faq/index.cgi?_highlightWords=meta
<http://www.openldap.org/faq/index.cgi?_highlightWords=meta&file=1085>
&file=1085
I don't think there is any restriction that one can't store Samba
data
in LDAP using BDB.
Could you re-configure OpenSSL with just "shared", prior to "make",
"make clean" to make sure you start from a clean state, and then
build
and install the OpenSSL binaries again.
Gary
-----Original Message-----
From: Henderson.David@mail.dc.state.fl.us
[mailto:Henderson.David@mail.dc.state.fl.us
<mailto:Henderson.David@mail.dc.state.fl.us> ]
Sent: Sat 10/15/2005 12:19 AM
To: Tay, Gary
Cc: openldap-software@OpenLDAP.org
Subject: RE: installation problems
Gary,
I changed the installation scripts back to using
the
"-I/usr/local/ssl/include" parameter. I also found out I was
compiling
a static library version of OpenSSL, which I have recompiled and
installed using "./config shared zlib-dynamic". Still bombs at the
same
point in the installation routine.
BTW, thanks for explaining those switches for
me.
Is it possible to have Samba use bdb as the backend instead of
"ldbm"?
What are meta definitions?
Thanks,
Dave Henderson
MCP, MCSA, MCSE, A+
Distributed Computer Systems Analyst
Florida Department of Corrections
Phone: 407.207.7391 Suncom: 343.7391
-----Original Message-----
From: Tay, Gary [mailto:Gary_Tay@platts.com
<mailto:Gary_Tay@platts.com> ]
Sent: Thursday, October 13, 2005 9:43 PM
To: Henderson, David
Subject: RE: installation problems
Looking at the config.log you post later I believe you
should
use "-I/usr/local/ssl/include".
Did you configure OpenSSL using "shared" option?
# cd openssl-0.9.7g
# ./config shared
# make clean
# make
# make install
"-enable-ldbm -enable-ldap -enable-meta"
The 1st one for some backend that SambaLDAP Tools
(smbldap-tools) assume, the OL developers favorites BDB and HDB
The 2nd for proxy server
The 3rd for meta defintions
Depends on what you need. That was why I said "something
like"...
Gary
-----Original Message-----
From: Henderson.David@mail.dc.state.fl.us
[mailto:Henderson.David@mail.dc.state.fl.us
<mailto:Henderson.David@mail.dc.state.fl.us> ]
Sent: Thursday, October 13, 2005 11:05 PM
To: Tay, Gary; quanah@stanford.edu;
ezra.taylor@gmail.com
Cc: openldap-software@OpenLDAP.org
Subject: RE: installation problems
Thanks guys/gals for your help with my problems. I
ended up using the syntax that Gary submitted to try to install, but
now
am getting the following error message...
Configure: error: Could not locate
TLS/SSL
package
I am positive that I have it installed. I did
notice
that during the configuration portion it is listing "Found ssl.h" as
no.
I even adjusted the below syntax to use
"/usr/local/ssl/include/openssl"
where applicable.
Another question I have is, why would I
want
to "-enable-ldbm -enable-ldap -enable-meta" if I am only going to
use
Berkeley DB. Can I remove those other types of authentication or do
I
still need them in order to use bdb?
Thanks,
Dave Henderson
MCP, MCSA, MCSE, A+
Distributed Computer Systems Analyst
Florida Department of Corrections
Phone: 407.207.7391 Suncom: 343.7391
-----Original Message-----
From: Tay, Gary [mailto:Gary_Tay@platts.com
<mailto:Gary_Tay@platts.com> ]
Sent: Tuesday, October 11, 2005 11:38 PM
To: Henderson, David
Subject: RE: installation problems
Try something like:
# env
LD_LIBRARY_PATH="/usr/local/lib:/usr/local/lib/sasl2:/usr/local/Berkeley
DB.4
.2/lib:/usr/local/ssl/lib" LDFLAGS="-L/usr/local/lib
-L/usr/local/lib/sasl2 -L/usr/local/BerkeleyDB.4.2/lib
-L/usr/local/ssl/lib -R/usr/local/lib -R/usr/local/lib/sasl2
-R/usr/local/BerkeleyDB.4.2/lib -R/usr/local/ssl/lib"
CPPFLAGS="-I/usr/local/include -I/usr/local/include/sasl
-I/usr/local/BerkeleyDB.4.2/include -I/usr/local/ssl/include"
./configure --enable-bdb --enable-ldbm --enable-ldap --enable-meta
--enable-crypt --with-tls --with-cyrus-sasl
Gary
-----Original Message-----
From: owner-openldap-software@OpenLDAP.org
[mailto:owner-openldap-software@OpenLDAP.org
<mailto:owner-openldap-software@OpenLDAP.org>
<mailto:owner-openldap-software@OpenLDAP.org
<mailto:owner-openldap-software@OpenLDAP.org> > ] On Behalf Of
Henderson.David@mail.dc.state.fl.us
Sent: Tuesday, October 11, 2005 11:28 PM
To: openldap-software@OpenLDAP.org
Subject: installation problems
Hi all,
I am having two problems while
installing
openLDAP. To give you a synopsis of what's happened so far... I
have
successfully installed the latest version (in this order) of
openSSL,
Berkeley DB (4.2.52.4), and Cyrus Sasl. I found that I should not
be
installing the latest version of BDB because of stability issues,
but
before finding that out, I had installed the latest. I removed all
the
files associated with the 4.3.x version and now get the following
error:
# export CPPFLAGS="-I/usr/local/include/
-I/usr/local/ssl/include/openssl/
-I/usr/local/BerkeleyDB.4.2/include/"
# export LDFLAGS="-L/usr/local/lib/
-L/usr/local/ssl/lib/ -L/usr/local/BerkeleyDB.4.2/lib/" #./configure
--with-cyrus-sasl --disable-cleartext --enable-spasswd
--enable-slurpd
--enable-bdb ... checking for sys/un.h... yes checking for
openssl/ssl.h... no checking for ssl.h... no
configure: warning: Could not locate TLS/SSL package
configure: warning: TLS data protection not
supported!
checking for _beginthread... no
checking for pthread.h... yes
...
checking number of arguments of gethostbyaddr_r... 8
checking for db.h... yes
checking for Berkeley DB link (default)... no
checking for Berkeley DB link (-ldb43)... no
checking for Berkeley DB link (-ldb-43)... no
checking for Berkeley DB link (-ldb-4.3)... no
checking for Berkeley DB link (-ldb-4-3)... no
checking for Berkeley DB link (-ldb42)... no
checking for Berkeley DB link (-ldb-42)... no
checking for Berkeley DB link (-ldb-4.2)... yes
checking for Berkeley DB version match... no
configure: error: Berkeley DB version mismatch
My other problem comes when configuring
the
openLDAP package. It keeps saying that I don't have SSL/TLS
installed,
but I do. In fact it is installed in its default location
(/usr/local/ssl). I have tried to install using the -with-ssl (or
whichever parameter it is), but nothing I do seems to assist the
configure script in finding the ssl header or library file. I have
also
tried modifying the CPPFLAGS and LDFLAGS to include the
/usr/local/ssl/include/openssl directories. Any help would be
greatly
appreciated.
Thanks,
Dave Henderson